ZT101Y Diving First Stage Head Regulator Brass Material Silver
Appearance
Regulator First stages ZT101Y
Descriptions
Superbalance diaphragm type first stage head, external adjustable relative medium pressure, allowing technicians to
quickly medium pressure fine tuning
The Marine grade brass body protects the internal components from
water and contaminants while improving cold water performance
The triangulated high and middle pressure hole position provides
abundant take over position, the main regulator and the standby
regulator can be installed side by side horizontally without
affecting each other
Specifications
| Ports | 4 medium pressure ports 3/8 "to 24UNF thread size, 2 high pressure
ports 7/16" to 20UNF thread size/fixed medium pressure hole size |
| Relative medium pressure | 0.9±0.1mpa |
| Model | Balanced diaphragm type |
| Type | DIN/INT is optional |
| Average output flow | 1000 L/min |
| Weight | 590 g /DIN |
Warning
(1) Do not assemble the low pressure tube on the high pressure hole
of the first level unloader (with HP), nor connect the high
pressure tube to the low pressure outlet of the first level
unloader.
(2) The two-stage compressor is the medium-pressure air from the
low-pressure outlet of the first-stage compressor, and the pressure
is 0.95± 0.05mpa.
Select the high pressure pipe and medium pressure pipe to connect
the hole.
Turn the high pressure plug and low pressure plug counterclockwise
using a hex wrench.
Reserve these high and low pressure plugs for future use.
Base some lubricating oil to end thread of tube and o-ring
(silicone oil may also be used, but silicone oil equipment should
not be used on high oxygen diving).
Turn the pressure pipe clockwise to the corresponding outlet and
use the torque tool to tighten the torque value. The torque value
of the tool should be 40in-lbs.
